Project:PURE

[subset7]

I've posted this project in a couple of other places and thought i'd post it here aswell and get the project logs started ,the build consists of a Lian Li G70,powder coated white outside,black inside with the roof cut out to house a PA120.3 and the floor cut out to house a PA120.2,window cut out and a few cable management holes.The hardware going inside will be:

Asus P6T Deluxe
Core i7 920
6Gb DDR3 Corsair Dominator 1600MHz
GTX 280
Antec Quattro 1000W PSU
1TB Samsung Spinpoint F1
500Gb Samsung Spinpoint F1

Cooling:

PA120.3
PA120.2
DDC-1T Pro/XSPC Top
DDC-1T Ultra/XSPC Top
2 x Bitspower 5.25 White bay res's
XSPC Delta V3 CPU Block
MIPS Mosfet and dual N/B-S/B Block
Danger Den White UV 3/8"IDx5/8"OD Hose
White Enermax Cluster Fans

Anyway here's the case





Cutouts for the PA120.2 and cable management holes



PA120.3 tapped for M4 bolts and test fitted







More updates soon

[Nitrix]

I do like the whole white + Black theme - finish it off with some white tube, black fittings and coils

[subset7]

Thanks Nitrix,i'm using white Danger Den hose but I wont be using coils,just keeping the tubing plain

Here's the fans and PA fixed to the case top







Top fitted back on case



Fitted the fans and fittings to the PA going in the bottom







Rad and fans fitted







Next update will be fitting the pumps and res's

[Nitrix]

I must say thats looking very slick!

cant wait for the next update!

[subset7]

Thanks Nitrix ,here's the res's i'm using









Got the tops on the pumps,braided and fitted







And the Res's







Thanks for looking

[Nitrix]

F**K me does that look good!

if i was going to get picky you could use black nickel compressions but it really does look nice.

What colour coolant you going to use?

[bentleya]

Great work Mark

[subset7]

@bentleya thanks
@Nitrix thanks,i'm using Feser clear UV blue
I thought i'd make a dust filter for the PA120.3 out of 2mm aluminium,here it is test fitted





Sprayed up and mesh fitted







Fitted to the rad





I got the mobo blocks fitted aswell,here's the board with stock cooling





Heatpipes off









The blocks i'm using,XSPC Delta V3



MIPS mobo blocks







The blocks fitted





Next update tomorrow with the tubing fitted for the first loop.

[Nitrix]

Looking good!

One thing about the feser you may want to test using it in a small bit of tubing in some cases the coolant color can show through the white tubing.

[subset7]

I've tried it and it's fine,with it being clear,it only turns blue under UV,the tube is 1/8" thick aswell so you can't see anything