Project:PURE

[subset7]

Thanks Nitrix,Just a small update,these are the modular molex cables,there are two of these



Plastic stoppers and plugs removed



Heat shrink on all the ends



With the plug fitted





Sleeved and aditional heat shrink over the join





And the PSU end



I did the front audio/usb cables aswell



I'd also like to add,this build is now sponsored by MNPCTech,Bill has kindly donated some of his 120mm Machined Billet Computer Fan Grills





I'll be powdercoating these and using them to replace the basic wire grills I have now,I think they'll improve the overall appearance of the case.that's all i've got for now,untill next time.

[Nitrix]

Perfectionist!

[subset7]

Haha thanks ,i'll try and get more done at the weekend.

[PeterStoba]

I've been following this build all over the place and I love it. So, how do I put it, white?

[subset7]

Thanks Peter ,Just a small update,the SATA cables that came with the board were a bit short so I got some 1m ones



So I sleeved these aswell



Heat shrink before





And after





And fitted



I also got the 120mm Machined Billet Computer Fan Grills from MNPCTech





I had planned on powdercoating the surround white,but when I seen them they look really nice so I decided to keep them as they are,here they are fitted











And with the fans running







I think these look much better than the wire grills

Also I got Mod of the Day over at HardOCP,which I didn't expect ,anyway that's all i've got for now,i'm hoping to get all the wiring finished at the weekend.

[xpdualcore]

OMG!!! I just luv this.....

A quick question.... what are the details of the compression fitting you used?

I am looking to be getting some soon for my build and like the clean look with no clamps.....

[Nitrix]

looking very very very nice

[subset7]

The compression fittings are 3/8"IDx5/8"OD,as is the hose and glad you like it

Thanks Nitrix

[subset7]

Been a while since I last updated this as I haven't had much time lately,anyway I sleeved the power/reset switches individually






Fitted back in the case


I got two of these displays to monitor the water temperature in the two res's



These are going in to one of the 5.25" bay covers which i've marked out



And after a few cuts with the Dremel





Before the displays go in I wanted to spray them white,which means dismantling them,to do this you need to cut the retaining slots on one side



Cut out with a sharp knife



Tha back should just pop open then





Tha PCB removed



Now i'm left with the piece I want to paint



Sprayed and clear coated



Test fitted in the cover





Just need to reassemble them now,I hope to get this finished at the weekend that's if the missus doesn't get on my case about doing the garden,it's starting to get a bit wild out there

[Nitrix]

Looking as slick as ever